⊙Home page

⊙Introduction

⊙Precision Timing Belt Range

⊙Belt Weight

⊙Belt Installation & Tensionin Center Distance Allowance
　Additional Center Disance Allo-
　wance for Flange Sprocket(s)

⊙Belt transmission installment

⊙Belt transmission maintenance

⊙Reason and correction measure expires which with the ambulacrum

The maintenance of the belt and the pulley

1.The belt can't be crimped and bend sharply,the minimum bending diameter:see the Figure 2.

2.During the process of the storage and the transportation,keep the belt and the pulley out of direct sunlight,not get wet from rain and snow,prevent it from touching the acid,alkali,
organic solvent and steam etc,which can influence property of the belt.

3.Storage under the usual temperature,from -20～50,and keep it away from heat source at least 1meter.

4. During the storage,it can't be piled up,for the weiht cause the change of the shape,and it can't be placed on the ground directly,it should be hanged on the shelf or put on the shelf.

5.The finished pulley should be stored and transported under a dry and ventilated environmint,and the anti-rust processing is also needed.

6.The belt gearing should have a protective cap,and the discharge of the pollution and ventilation must be assured.

Figure 2:The minimum crimp diameter of timing belt