⊙Home page

⊙Introduction

⊙Precision Timing Belt Range

⊙Belt Weight

⊙Belt Installation & Tensionin Center Distance Allowance
　Additional Center Disance Allo-
　wance for Flange Sprocket(s)

⊙Belt transmission installment

⊙Belt transmission maintenance

⊙Reason and correction measure expires which with the ambulacrum

Belt Installation & Tensioning

　To ensure easy laying of the belt into sprocket and tensioning of the belt,
synchronous drive system should have sufficient installation and tension allowances.

　The installation allowance is the minimum decrease required in the center distance for easy insallation of the belt,when the flanged sprockets removed from the shaft.

　Standard installation allowances are shown in Table A.Table B shows additional center distance allowances for installation when the belt is to be installed over flaged sprocket(s) without removing it/them.The belt should never be forced over sprocket flanges by lever;this may cause permanent damage of tension member inside the belt.

Table A:Center Distance Allowance(mm)

Table B:Additional Allowance for Flaged Sprocket(s)